Back to SMD Home Page

Shop Tour Index Facilities Receiving Area Dirt Room Area Calibration Area:    Sunnen inside micrometer set > Bearing Bore Specification    Measuring run-out w/balancing ways    Shaft and bearing damage    Cleaned, machined spindle rotor    Entek IRD balancing machine    Certificate of Calibration Winding Department Assembly Area Test Room Area Shipping Department Robotics & Electronics Div.

All bearing bores are measured using SKF bearing specifications. Servo does not use loctite or tolerance rings. Servo only uses steel sleeved out of tolerance bearing bores, a better quality material than the aluminum so many of the manufacturers use in their servo and spindle motors.